![]() Horizontal Distribute Center - The centers of the selected nodes are distributed evenly between the left-most and right-most nodes, which should stay stationary. Horizontal Distribute Left - The left hand sides of the selected nodes are distributed evenly between the left-most and right-most nodes, which should stay stationary. Vertical Distribute Bottom - The bottoms of the selected nodes are distributed evenly between the top-most and bottom-most nodes, which should stay stationary. Vertical Distribute Center - The centers of the selected nodes are distributed evenly between the top-most and bottom-most nodes, which should stay stationary. Vertical Distribute Top - The tops of the selected nodes are distributed evenly between the top-most and bottom-most nodes, which should stay stationary. Horizontal Align Right - The right hand sides of the selected nodes are aligned with the right-most node. Horizontal Align Center - The centers of the selected nodes are aligned along a line defined by the midpoint between the left and right-most nodes. Horizontal Align Left - The left hand sides of the selected nodes are aligned with the left-most node. Vertical Align Bottom - The bottoms of the selected nodes are aligned with the bottom-most node. Vertical Align Center - The centers of the selected nodes are aligned along a line defined by the midpoint between the top and bottom-most nodes. Vertical Align Top - The tops of the selected nodes are aligned with the top-most node. Vertically or horizontally stacks selected nodes with the fullĬomplement of alignment options. Node is used as a reference point for the distribution. The differences are again a function what part of the Distribute evenly distributes selected nodesīetween the two most distant nodes along either the vertical or the center of the node, the top of the node, the The Tool Panel contains buttons to set relative postions of nodes.ĭifferent options for either vertically or horizontally aligning Likewise, if you don’t want any annotations to be selected, toggle the button off.And if you don’t want any edges to be selected, toggle the button off.So if you don’t want any nodes to be selected, toggle the button off. ![]() In order to enable or disable the selection of an element type, just toggle its corresponding button at the bottom of the network view (see image below) or use the options under the menu Select → Mouse Drag Selects.
0 Comments
Leave a Reply. |